国产亚洲欧美在线中文_日韩高清亚洲二区中文字幕_中文字幕在线看看_国产特黄观看视频_中文字幕精品无码—人妻熟_日韩精品欧美一区国产_日韩欧美另类一区在线_成人电影AV在线_亚洲熟妇熟女久久精品_一级欧美牲交大片

The thermal insulation and decoration integration completes most of the processes of the building exterior wall thermal insulation and decoration system in the factory. Workers only need to perform simple installation at the construction site, which can solve the common quality problems of building energy-saving and thermal insulation projects and fire safety problems. After mixing and cooling in the plastic extruder and static mixer or heat exchanger, the cooled gel passes through the mold into the area where the pressure is reduced or reduced to form a foam structure.

The concrete inside the thermal insulation and decoration integration forms closed foam holes, making the concrete lightweight and thermally insulated. Then, a good quality cement insulation board should feel good and be light, because the density of foam concrete is small, which can reduce the deadweight of the building. Install according to the design to effectively avoid uneven arrangement. Also pay attention to the glue problem. If the glue quality is not good enough, debonding will occur, which will affect the final installation effect. High-quality glue should be used for installation, and the correctness of the glue should be ensured.

Secondly, the thermal insulation and decoration integration should prevent direct sunlight. Because of the special material of the thermal insulation board, if it is exposed to direct sunlight for a long time, it will age or deform, which will reduce the performance of the thermal insulation board. First, the quality of the material. Only high-quality materials can achieve the expected use effect. Materials with quality problems not only cannot achieve the expected use effect, but may even cause engineering quality problems. In order to avoid this problem.

Apply polymer mortar on the surface layer of the thermal insulation and decoration integration. Pay attention to control the thickness. If the plaster layer can just cover the mesh cloth, it means that the thickness is appropriate, generally about 1mm. When using prefabricated blocks for pre-pressing, the middle and then the two sides should be pressurized first, and the pre-pressed blocks should be placed steadily and gently; when adjusting the position of the pre-pressed blocks, they should be lifted and moved parallel to the top surface of the thermal insulation and decoration materials.